[sisyphus] wifi wpa BCM43142

[Andrey Korotchenko]

День добрый
не получается подсоединиться по wifi
Оборудование было рабочим и работало в прошлом с какой то версией Линукс

Имеем следующее:
# uname -a
Linux kaa 3.19.2-un-def-alt1 #1 SMP PREEMPT Wed Mar 18 19:09:44 UTC 2015
x86_64 GNU/Linux

# rpm -qa|grep kernel
kernel-modules-virtualbox-un-def-4.3.22-alt1.201474.1
kernel-modules-drm-un-def-3.19.2-alt1
kernel-headers-common-1.2.4-alt1
kernel-image-un-def-3.19.2-alt1
kernel-modules-bcmwl-un-def-6.30.223.248-alt6.201474.1
update-kernel-0.9.6-alt1

# lspci |grep Network
03:00.0 Network controller: Broadcom Corporation BCM43142 802.11b/g/n (rev
01)

# lsmod |grep wl
wl                   6363557  0
cfg80211              536800  1 wl

# iw dev wlp3s0 link
Not connected.


Попробывал произвести настройку wifi без NetworkManager(с ним не
получилось, не хотел авторизоваться, пароль правильный и на телефоне
работает)
следующим образом при остановленом NetworkManager:
# iw dev wlp3s0 scan
BSS c8:3a:35:40:0c:78(on wlp3s0)
        TSF: 0 usec (0d, 00:00:00)
        freq: 2437
        beacon interval: 100 TUs
        capability: ESS Privacy (0x0011)
        signal: -56.00 dBm
        last seen: 0 ms ago
        SSID: relex101
        Supported rates: 1.0* 2.0* 5.5* 11.0* 9.0 18.0 36.0 54.0
        DS Parameter set: channel 6
        Extended supported rates: 6.0 12.0 24.0 48.0
        TIM: DTIM Count 0 DTIM Period 1 Bitmap Control 0x0 Bitmap[0] 0x8
        ERP: Barker_Preamble_Mode
        HT capabilities:
                Capabilities: 0x11ee
                        HT20/HT40
                        SM Power Save disabled
                        RX HT20 SGI
                        RX HT40 SGI
                        TX STBC
                        RX STBC 1-stream
                        Max AMSDU length: 3839 bytes
                        DSSS/CCK HT40
                Maximum RX AMPDU length 65535 bytes (exponent: 0x003)
                Minimum RX AMPDU time spacing: 4 usec (0x05)
                HT RX MCS rate indexes supported: 0-15, 32
                HT TX MCS rate indexes are undefined
        HT operation:
                 * primary channel: 6
                 * secondary channel offset: above
                 * STA channel width: any
                 * RIFS: 0
                 * HT protection: nonmember
                 * non-GF present: 1
                 * OBSS non-GF present: 0
                 * dual beacon: 0
                 * dual CTS protection: 0
                 * STBC beacon: 0
                 * L-SIG TXOP Prot: 0
                 * PCO active: 0
                 * PCO phase: 0
        Extended capabilities: HT Information Exchange Supported
        RSN:     * Version: 1
                 * Group cipher: TKIP
                 * Pairwise ciphers: TKIP CCMP
                 * Authentication suites: PSK
                 * Capabilities: PreAuth (0x0001)
        WMM:     * Parameter version 1
                 * BE: CW 15-1023, AIFSN 3
                 * BK: CW 15-1023, AIFSN 7
                 * VI: CW 7-15, AIFSN 2, TXOP 3008 usec
                 * VO: CW 3-7, AIFSN 2, TXOP 1504 usec
        BSS Load:
                 * station count: 1
                 * channel utilisation: 63/255
                 * available admission capacity: 31250 [*32us]

# iw dev wlp3s0 set type managed

# iw dev wlp3s0 info
Interface wlp3s0
        ifindex 6
        wdev 0x1
        addr 30:10:b3:01:26:b3
        ssid relex101
        type managed
        wiphy 0

# wpa_supplicant -i wlp3s0 -c <(wpa_passphrase "relex101" "somepasswd")
Successfully initialized wpa_supplicant
wlp3s0: Trying to associate with c8:3a:35:40:0c:78 (SSID='relex101'
freq=2437 MHz)
wlp3s0: Authentication with c8:3a:35:40:0c:78 timed out.
wlp3s0: CTRL-EVENT-DISCONNECTED bssid=c8:3a:35:40:0c:78 reason=3
locally_generated=1
wlp3s0: Trying to associate with c8:3a:35:40:0c:78 (SSID='relex101'
freq=2437 MHz)
wlp3s0: CTRL-EVENT-ASSOC-REJECT bssid=c8:3a:35:40:0c:78 status_code=16
wlp3s0: Trying to associate with c8:3a:35:40:0c:78 (SSID='relex101'
freq=2437 MHz)
wlp3s0: CTRL-EVENT-ASSOC-REJECT bssid=c8:3a:35:40:0c:78 status_code=16
wlp3s0: CTRL-EVENT-SSID-TEMP-DISABLED id=0 ssid="relex101" auth_failures=1
duration=10 reason=CONN_FAILED
wlp3s0: CTRL-EVENT-SSID-REENABLED id=0 ssid="relex101"
wlp3s0: Trying to associate with c8:3a:35:40:0c:78 (SSID='relex101'
freq=2437 MHz)
wlp3s0: Authentication with c8:3a:35:40:0c:78 timed out
....

Подскажите что у меня не так ;) (пароль верный)
Но пока что больше похоже что проблема с софтом.
----------- следующая часть -----------
Вложение в формате HTML было удалено...
URL: <http://lists.altlinux.org/pipermail/sisyphus/attachments/20150327/d91bb000/attachment.html>