[sisyphus] проблема при подсоединении винта - mount: Stale NFS file handle

[Peter Evdokimov]

Hello, ALT Linux Sisyphus discussions <sisyphus на lists.altlinux.org>.

пытаюсь подцепить внешний sata винт.

в логах:

usb 2-3: new high speed USB device using ehci_hcd and address 3
usb 2-3: configuration #1 chosen from 1 choice
usb 2-3: New USB device found, idVendor=152d, idProduct=2338
usb 2-3: New USB device strings: Mfr=1, Product=2, SerialNumber=5
usb 2-3: Product: JM20338 SATA, USB Combo
usb 2-3: Manufacturer: JMicron
usb 2-3: SerialNumber: 888888888888
usbcore: registered new interface driver libusual
Initializing USB Mass Storage driver...
scsi4 : SCSI emulation for USB Mass Storage devices
usbcore: registered new interface driver usb-storage
USB Mass Storage support registered.
scsi 4:0:0:0: Direct-Access     ST375064             5QD1 3.AA PQ: 0 ANSI: 2 CCS
sd 4:0:0:0: [sdb] 1465149168 512-byte hardware sectors (750156 MB)
sd 4:0:0:0: [sdb] Write Protect is off
sd 4:0:0:0: [sdb] Assuming drive cache: write through
sd 4:0:0:0: [sdb] 1465149168 512-byte hardware sectors (750156 MB)
sd 4:0:0:0: [sdb] Write Protect is off
sd 4:0:0:0: [sdb] Assuming drive cache: write through
sdb: sdb1 < sdb5 >
sd 4:0:0:0: [sdb] Attached SCSI disk
sd 4:0:0:0: Attached scsi generic sg2 type 0

при монтировании через mount - mount: Stale NFS file handle

гугленье не помогло. куда рыть?

sy,
	peter