[Hardware] 3 ware

[Anton Gorlov]

После  10 дней аптайма файлопомйки в логе вылетело

3w-9xxx: scsi4: AEN: WARNING (0x04:0x0039): Buffer ECC error
corrected:address=0x1C11E00.
3w-9xxx: scsi4: AEN: WARNING (0x04:0x0039): Buffer ECC error
corrected:address=0x1A59020.
3w-9xxx: scsi4: AEN: WARNING (0x04:0x0039): Buffer ECC error
corrected:address=0x227D020.

железка -
01:00.0 RAID bus controller: 3ware Inc Unknown device 1004 (rev 01)
          Subsystem: 3ware Inc Unknown device 1004
          Flags: bus master, fast devsel, latency 0, IRQ 169
          Memory at bc000000 (64-bit, prefetchable) [size=32M]
          Memory at ff5ff000 (64-bit, non-prefetchable) [size=4K]
          I/O ports at a800 [size=256]
          Memory at ff5fe000 (32-bit, non-prefetchable) [size=4K]
          Expansion ROM at ff5c0000 [disabled] [size=128K]
          Capabilities: [40] Power Management version 2
          Capabilities: [50] Message Signalled Interrupts: Mask- 64bit+
Queue=0/5
Enable-
          Capabilities: [70] Express Legacy Endpoint IRQ 0


256 мб памяти и батарейка.

3ware 9000 Storage Controller device driver for Linux v2.26.02.008.
ACPI: PCI Interrupt 0000:01:00.0[A] -> GSI 16 (level, low) -> IRQ 169
PCI: Setting latency timer of device 0000:01:00.0 to 64
scsi4 : 3ware 9000 Storage Controller
3w-9xxx: scsi4: Found a 3ware 9000 Storage Controller at 0xff5ff000,
IRQ: 169.
3w-9xxx: scsi4: Firmware FE9X 3.06.00.003, BIOS BE9X 3.06.00.002, Ports: 8.
    Vendor: AMCC      Model: 9650SE-8LP DISK   Rev: 3.06
    Type:   Direct-Access                      ANSI SCSI revision: 05


Нести ли железку по гарантии?