[Hardware] hdparm -t ... 2.09 MB/sec !?

[Andrei Lomov]

Что-то моему уму непостижимое :(

Заменили m/b на машине (вроде как апгрейд),
и скорость винта упала в сорок раз.

m/b AK75-EC : 
Винт Seagate 250 Gb стоит на первом контроллере мастером, слэйва нет.
Биос видит его нормально.

# /sbin/hdparm -t /dev/hda
/dev/hda:
 Timing buffered disk reads:    8 MB in  3.84 seconds =   2.09 MB/sec


# /sbin/hdparm -i /dev/hda
/dev/hda:
 Model=ST3250823A, FwRev=3.03, SerialNo=5ND0RV7P
 Config={ HardSect NotMFM HdSw>15uSec Fixed DTR>10Mbs RotSpdTol>.5% }
 RawCHS=16383/16/63, TrkSize=0, SectSize=0, ECCbytes=4
 BuffType=unknown, BuffSize=8192kB, MaxMultSect=16, MultSect=16
 CurCHS=65535/1/63, CurSects=4128705, LBA=yes, LBAsects=268435455
 IORDY=on/off, tPIO={min:240,w/IORDY:120}, tDMA={min:120,rec:120}
 PIO modes:  pio0 pio1 pio2 pio3 pio4
 DMA modes:  mdma0 mdma1 mdma2
 UDMA modes: udma0 udma1 udma2 udma3 udma4 *udma5
 AdvancedPM=no WriteCache=enabled
 Drive conforms to: device does not report version:

/var/log/dmesg:
Linux version 2.6.12-std26-up-alt6 (builder на salto.malta.altlinux.ru) (gcc
version 3.4.4 20050526 (ALT Linux, build 3.4.4-alt1)) #1 Thu Oct 27
10:34:10 MSD 2005
BIOS-provided physical RAM map:
 BIOS-e820: 0000000000000000 - 000000000009fc00 (usable)
 BIOS-e820: 000000000009fc00 - 00000000000a0000 (reserved)
 BIOS-e820: 00000000000f0000 - 0000000000100000 (reserved)
 BIOS-e820: 0000000000100000 - 0000000017ff0000 (usable)
 BIOS-e820: 0000000017ff0000 - 0000000017ff3000 (ACPI NVS)
 BIOS-e820: 0000000017ff3000 - 0000000018000000 (ACPI data)
 BIOS-e820: 00000000ffff0000 - 0000000100000000 (reserved)
0MB HIGHMEM available.
383MB LOWMEM available.
On node 0 totalpages: 98288
  DMA zone: 4096 pages, LIFO batch:1
  Normal zone: 94192 pages, LIFO batch:31
  HighMem zone: 0 pages, LIFO batch:1
DMI 2.2 present.
ACPI: RSDP (v000 VIA694                                ) @ 0x000f6dc0
ACPI: RSDT (v001 VIA694 AWRDACPI 0x42302e31 AWRD 0x00000000) @ 0x17ff3000
ACPI: FADT (v001 VIA694 AWRDACPI 0x42302e31 AWRD 0x00000000) @ 0x17ff3040
ACPI: DSDT (v001 VIA694 AWRDACPI 0x00001000 MSFT 0x0100000c) @ 0x00000000
ACPI: PM-Timer IO Port: 0x4008
Allocating PCI resources starting at 18000000 (gap: 18000000:e7ff0000)
Built 1 zonelists
Kernel command line: auto BOOT_IMAGE=ALT_Linux_3.0 ro root=306
Local APIC disabled by BIOS -- you can enable it with "lapic"
mapped APIC to ffffd000 (01302000)
Initializing CPU#0
PID hash table entries: 2048 (order: 11, 32768 bytes)
Detected 1713.484 MHz processor.
Using pmtmr for high-res timesource
Console: colour dummy device 80x25
Dentry cache hash table entries: 65536 (order: 6, 262144 bytes)
Inode-cache hash table entries: 32768 (order: 5, 131072 bytes)
Memory: 386016k/393152k available (1496k kernel code, 6584k reserved, 738k
data, 184k init, 0k highmem)
Checking if this processor honours the WP bit even in supervisor mode... Ok.
Calibrating delay loop... 3391.48 BogoMIPS (lpj=1695744)
Security Framework v1.0.0 initialized
Capability LSM initialized
Mount-cache hash table entries: 512
CPU: After generic identify, caps: 0383f9ff c1c3f9ff 00000000 00000000
00000000 00000000 00000000
CPU: After vendor identify, caps: 0383f9ff c1c3f9ff 00000000 00000000
00000000 00000000 00000000
CPU: CLK_CTL MSR was 6003d223. Reprogramming to 2003d223
CPU: L1 I Cache: 64K (64 bytes/line), D cache 64K (64 bytes/line)
CPU: L2 Cache: 256K (64 bytes/line)
CPU: After all inits, caps: 0383f9ff c1c3f9ff 00000000 00000020 00000000
00000000 00000000
Intel machine check architecture supported.
Intel machine check reporting enabled on CPU#0.
CPU: AMD Athlon XP (Tbre stepping 01
Enabling fast FPU save and restore... done.
Enabling unmasked SIMD FPU exception support... done.
Checking 'hlt' instruction... OK.
ACPI: Looking for DSDT in initrd... not found!
ACPI: setting ELCR to 0200 (from 0e88)
checking if image is initramfs...it isn't (no cpio magic); looks like an
initrd
Freeing initrd memory: 399k freed
NET: Registered protocol family 16
PCI: PCI BIOS revision 2.10 entry at 0xfb440, last bus=1
PCI: Using configuration type 1
mtrr: v2.0 (20020519)
ACPI: Subsystem revision 20050309
ACPI: Interpreter enabled
ACPI: Using PIC for interrupt routing
ACPI: PCI Root Bridge [PCI0] (0000:00)
PCI: Probing PCI hardware (bus 00)
Boot video device is 0000:01:00.0
ACPI: PCI Interrupt Routing Table [\_SB_.PCI0._PRT]
ACPI: PCI Interrupt Link [LNKA] (IRQs 1 3 4 5 6 *7 10 11 12 14 15)
ACPI: PCI Interrupt Link [LNKB] (IRQs 1 *3 4 5 6 7 10 11 12 14 15)
ACPI: PCI Interrupt Link [LNKC] (IRQs 1 3 4 5 6 7 *10 11 12 14 15)
ACPI: PCI Interrupt Link [LNKD] (IRQs 1 3 4 5 6 7 10 *11 12 14 15)
Linux Plug and Play Support v0.97 (c) Adam Belay
pnp: PnP ACPI init
pnp: PnP ACPI: found 10 devices
PnPBIOS: Disabled by ACPI PNP
PCI: Using ACPI for IRQ routing
PCI: If a device doesn't work, try "pci=routeirq".  If it helps, post a
report
audit: initializing netlink socket (disabled)
audit(1196348864.558:0): initialized
Total HugeTLB memory allocated, 0
VFS: Disk quotas dquot_6.5.1
Dquot-cache hash table entries: 1024 (order 0, 4096 bytes)
Initializing Cryptographic API
Applying VIA southbridge workaround.
PCI: Disabling Via external APIC routing
vesafb: framebuffer at 0xd8000000, mapped to 0xd8880000, using 4096k, total
4096k
vesafb: mode is 1280x1024x16, linelength=2560, pages=0
vesafb: protected mode interface info at c000:0336
vesafb: scrolling: redraw
vesafb: Truecolor: size=0:5:6:5, shift=0:11:5:0
bootsplash 3.1.6-2004/03/31: looking for picture...<6> silentjpeg size
165339 bytes,<6>...found (1280x1024, 24181 bytes, v3).
Console: switching to colour frame buffer device 160x61
fb0: VESA VGA frame buffer device
isapnp: Scanning for PnP cards...
isapnp: No Plug & Play device found
PNP: PS/2 controller doesn't have KBD irq; using default 0x1
PNP: PS/2 Controller [PNP0f13:PS2M] at 0x60,0x64 irq 1,12
serio: i8042 AUX port at 0x60,0x64 irq 12
serio: i8042 KBD port at 0x60,0x64 irq 1
io scheduler noop registered
io scheduler anticipatory registered
io scheduler deadline registered
io scheduler cfq registered
RAMDISK driver initialized: 16 RAM disks of 12288K size 1024 blocksize
mice: PS/2 mouse device common for all mice
md: md driver 0.90.1 MAX_MD_DEVS=256, MD_SB_DISKS=27
NET: Registered protocol family 2
IP: routing cache hash table of 4096 buckets, 32Kbytes
TCP established hash table entries: 16384 (order: 5, 131072 bytes)
TCP bind hash table entries: 16384 (order: 4, 65536 bytes)
TCP: Hash tables configured (established 16384 bind 16384)
NET: Registered protocol family 1
ACPI wakeup devices: 
SLPB PCI0 USB0 USB1 MODM UAR1 ECP1 
ACPI: (supports S0 S3 S4 S5)
md: Autodetecting RAID arrays.
md: autorun ...
md: ... autorun DONE.
RAMDISK: Compressed image found at block 0
VFS: Mounted root (romfs filesystem) readonly.
Uniform Multi-Platform E-IDE driver Revision: 7.00alpha2
ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx
Probing IDE interface ide0...
hda: ST3250823A, ATA DISK drive
Probing IDE interface ide1...
hdc: _NEC DVD_RW ND-3520A, ATAPI CD/DVD-ROM drive
hdd: CD-W540E, ATAPI CD/DVD-ROM drive
ide0 at 0x1f0-0x1f7,0x3f6 on irq 14
ide1 at 0x170-0x177,0x376 on irq 15
hda: max request size: 1024KiB
hda: 488397168 sectors (250059 MB) w/8192KiB Cache, CHS=30401/255/63
hda: cache flushes supported
 hda: hda1 hda2 hda3 hda4 < hda5 hda6 hda7 hda8 hda9 >
kjournald starting.  Commit interval 5 seconds
EXT3-fs: mounted filesystem with ordered data mode.
VFS: Mounted root (ext3 filesystem) readonly.
Trying to move old root to /initrd ... failed
Unmounting old root
Trying to free ramdisk memory ... okay
Freeing unused kernel memory: 184k freed
Executing init=/sbin/init
Real Time Clock Driver v1.12
EXT3 FS on hda6, internal journal
device-mapper: 4.4.0-ioctl (2005-01-12) initialised: dm-devel на redhat.com
Adding 1052216k swap on /dev/hda7.  Priority:-1 extents:1
NTFS driver 2.1.22 [Flags: R/W MODULE].
NTFS-fs warning (device hda1): parse_options(): Option iocharset is
deprecated. Please use option nls=<charsetname> in the future.
NTFS volume version 3.1.
kjournald starting.  Commit interval 5 seconds
EXT3-fs warning: maximal mount count reached, running e2fsck is recommended
EXT3 FS on hda8, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
kjournald starting.  Commit interval 5 seconds
EXT3 FS on hda9, internal journal
EXT3-fs: mounted filesystem with ordered data mode.
loop: loaded (max 64 devices)
EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended
EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended
EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended
EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended
EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended
EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended
EXT2-fs warning: mounting unchecked fs, running e2fsck is recommended
ISO 9660 Extensions: Microsoft Joliet Level 3
ISO 9660 Extensions: RRIP_1991A
ISO 9660 Extensions: Microsoft Joliet Level 3
ISO 9660 Extensions: RRIP_1991A
ISO 9660 Extensions: Microsoft Joliet Level 3
ISOFS: changing to secondary root
ISO 9660 Extensions: Microsoft Joliet Level 3
ISOFS: changing to secondary root
ISO 9660 Extensions: Microsoft Joliet Level 3
ISOFS: changing to secondary root
ISO 9660 Extensions: Microsoft Joliet Level 3
ISOFS: changing to secondary root
spurious 8259A interrupt: IRQ7.


-- 
Всего доброго,
А.Л.