[Hardware] i810 и разрешения больше 1024x768

Genix genix на list.ru
Пт Мар 18 12:25:55 MSK 2005


Sergey Vlasov wrote:

> Вероятно, этот режим чем-то не нравится X-серверу.  Поищите
> соответствующие записи в логе.

смотрел несколько раз, ничего похожего не видно. лог прилагается.
В кратце:

$ bzcat Xorg.0.log.bz2 | grep '^(WW)'
(WW) Open APM failed (/dev/apm_bios) (No such device)
(WW) I810(0): Bad V_BIOS checksum
(WW) I810(0): Extended BIOS function 0x5f11 not supported.
(WW) I810(0): Bad V_BIOS checksum
(WW) I810(0): Bad V_BIOS checksum
(WW) I810(0): Failed to set up write-combining range (0xd8000000,0x8000000)
(WW) I810(0): PGTBL_ER is 0x00000049
(WW) I810(0): Extended BIOS function 0x5f05 failed.
(WW) I810(0): Failed to set refresh rate to 99Hz.
(WW) I810(0): Extended BIOS function 0x5f61 not supported.
(WW) I810(0): Option "AGPMode" is not used

Конфиг на всякий случай тоже прилагается.
Со вчерашнего дня в нем только изменился modeline (взят с 
http://koala.ilog.fr/cgi-bin/nph-colas-modelines как советуют в faq), 
добавилась опция "DisplayInfo" "FALSE" и  "XaaNoOffScreenPixmaps" а 
также значение "AGPMode" изменено на "4" (результат чтения архивов).
Плюс, удалены все пакеты nvidia (до этого стояла она) и сделана ссылка 
libGL.so.1 -> libGL.so. Теперь glxinfo рапортует о том что direct 
rendering присутствует, xvinfo говорит что X-Video в наличии. А вот 
разрешение 1152x864 не ставится.



> И откуда взялись такие hfreq и vfreq в комментариях?

gtf, вроде.
пробовал другие -- результат тот же

>>(II) I810(0): #2: hsize: 1024  vsize 768  refresh: 100  vid: 26721
>>(II) I810(0): #3: hsize: 1152  vsize 864  refresh: 85  vid: 22897
>>
>>         ^^^^^^^^^^^^^^^^^^^^ вот он!! ^^^^^^^^^^^^^^^^^^^^^
> 
> 
> Это режим, поддерживаемый монитором - большую часть этих сведений X
> фактически не использует.  Где-то после этого в логе должен быть довольно
> большой список режимов с указанием, почему они не используются.

Не нашел, чесслово.
Есть сообщения вида:
*(II) I810(0): Not using built-in mode "1280x1024" (hsync out of range)
и

>>(II) I810(0): Not using mode "1152x864" (no mode of this name)

а подробностей нет :(

> Значит, все такие режимы (в том числе встроенные в X) не подошли по
> каким-то параметрам.

А надежда есть? Карта+монитор гарантировано держат этот режим.

-- 
У каждого в башке свои тараканы...
-------------- next part --------------

# File generated by XFdrake.

# **********************************************************************
# Refer to the XF86Config(4/5) man page for details about the format of
# this file.
# **********************************************************************

Section "Files"

    RgbPath	"/usr/X11R6/lib/X11/rgb"

# Multiple FontPath entries are allowed (they are concatenated together)
# By default, Mandrake 6.0 and later now use a font server independent of
# the X server to render fonts.

    FontPath   "unix/:-1"

EndSection

# **********************************************************************
# Server flags section.
# **********************************************************************

Section "ServerFlags"

    # Uncomment this to cause a core dump at the spot where a signal is
    # received.  This may leave the console in an unusable state, but may
    # provide a better stack trace in the core dump to aid in debugging
    #NoTrapSignals

    # Uncomment this to disable the <Crtl><Alt><BS> server abort sequence
    # This allows clients to receive this key event.
    #DontZap

    # Uncomment this to disable the <Crtl><Alt><KP_+>/<KP_-> mode switching
    # sequences.  This allows clients to receive these key events.
    #DontZoom

    # This  allows  the  server  to start up even if the
    # mouse device can't be opened/initialised.
    AllowMouseOpenFail

EndSection

# **********************************************************************
# Input devices
# **********************************************************************

# **********************************************************************
# Keyboard section
# **********************************************************************

Section "InputDevice"

    Identifier "Keyboard1"
    Driver      "kbd"
    Option "AutoRepeat"  "250 30"

    Option "XkbModel" "pc105"
    Option "XkbLayout" "us,ru"
    Option "XkbVariant"  ",winkeys"
    Option "XkbOptions"  "grp:ctrl_shift_toggle,grp:switch,grp_led:scroll"

EndSection

# **********************************************************************
# Pointer section
# **********************************************************************

Section "InputDevice"

    Identifier  "Mouse1"
    Driver      "mouse"
    Option "Protocol"    "IMPS/2"
    Option "Device"      "/dev/psaux"
    Option "ZAxisMapping" "4 5"
#    Option "Emulate3Buttons"
#    Option "Emulate3Timeout"    "50"

# ChordMiddle is an option for some 3-button Logitech mice

#    Option "ChordMiddle"

EndSection



Section "Module"

# This loads the DBE extension module.

    Load	"dbe"

# This loads the Video for Linux module.
#    Load        "v4l"

# This loads the NVIDIA GLX extension module.
# IT IS IMPORTANT TO KEEP NAME AS FULL PATH TO libglx.so ELSE
# IT WILL LOAD XFree86 glx module and the server will crash.

    Load        "glx"
    Load        "dri"


# This loads the miscellaneous extensions module, and disables
# initialisation of the XFree86-DGA extension within that module.

    SubSection	"extmod"
	Option	"omit xfree86-dga"

    EndSubSection

# This loads the Type1 and FreeType font modules

    Load	"type1"
    Load	"freetype"
EndSection

# **********************************************************************
# Monitor section
# **********************************************************************

# Any number of monitor sections may be present

Section "Monitor"
    Identifier "CTX|CTX PR705F series"
    VendorName "CTX"
    ModelName  "Unknown"


# HorizSync is in kHz unless units are specified.
# HorizSync may be a comma separated list of discrete values, or a
# comma separated list of ranges of values.
# NOTE: THE VALUES HERE ARE EXAMPLES ONLY.  REFER TO YOUR MONITOR'S
# USER MANUAL FOR THE CORRECT NUMBERS.
    HorizSync  30-86


# VertRefresh is in Hz unless units are specified.
# VertRefresh may be a comma separated list of discrete values, or a
# comma separated list of ranges of values.
# NOTE: THE VALUES HERE ARE EXAMPLES ONLY.  REFER TO YOUR MONITOR'S
# USER MANUAL FOR THE CORRECT NUMBERS.
    VertRefresh 50-160


# This is a set of extended mode timings typically used for laptop,
# TV fullscreen mode or DVD fullscreen output.
# These are available along with standard mode timings.

# Sony Vaio C1(X,XS,VE,VN)?
# 1024x480 @ 85.6 Hz, 48 kHz hsync
ModeLine "1024x480"    65.00 1024 1032 1176 1344   480  488  494  563 -hsync -vsync

# 768x576 @ 79 Hz, 50 kHz hsync
ModeLine "768x576"     50.00  768  832  846 1000   576  590  595  630
# 768x576 @ 100 Hz, 61.6 kHz hsync
ModeLine "768x576"     63.07  768  800  960 1024   576  578  590  616

# Added by genix (1024x768 at 100 Hz)
ModeLine "1024x768"    113.303 1024 1096 1208 1392  768 769 772 814 -hsync +vsync
# Added by genix (1280x1024 at 85 Hz)
ModeLine "1280x1024"  159.36  1280 1376 1512 1744  1024 1025 1028 1075  -HSync +Vsync
# 1152x864, 85.0Hz; hfreq=0.000000, vfreq=0.000000
#ModeLine "1152x864"   121.50 1152 1216 1344 1568  864  865  868  911  +hsync +vsync

# http://koala.ilog.fr/cgi-bin/nph-colas-modelines
ModeLine "1152x864" 131.91 1152 1200 1440 1536 864 866 878 904 #95Hz

EndSection



# **********************************************************************
# Graphics device section
# **********************************************************************

Section "Device"
    Identifier "Generic VGA"
    Driver     "vga"
EndSection

Section "Device"
    Identifier  "Intel i845"
    VendorName  "Unknown"
    BoardName   "Unknown"
    Driver      "i810"
    VideoRam    32768
    # Clock lines


    # Uncomment following option if you see a big white block        
    # instead of the cursor!                                          
    #    Option      "sw_cursor"

    Option	"DisplayInfo" "FALSE"
    Option	"XaaNoOffScreenPixmaps"
    Option      "AGPMode"  "4"
    Option      "DPMS"  "on"
EndSection



# **********************************************************************
# Screen sections
# **********************************************************************


Section "Screen"
    Identifier "screen1"
    Device      "Intel i845"
    Monitor     "CTX|CTX PR705F series"
    DefaultColorDepth 24
    Subsection "Display"
        Depth       8
        Modes       "1280x1024" "1152x864" "1024x768" "800x600" "640x400"
        ViewPort    0 0
    EndSubsection
    Subsection "Display"
        Depth       16
        Modes       "1280x1024" "1152x864" "1024x768" "800x600" "640x480"
        ViewPort    0 0
    EndSubsection
    Subsection "Display"
        Depth       24
        Modes       "1280х1024" "1152x864" "1024x768" "800x600" "640x480"
        ViewPort    0 0
    EndSubsection
    Subsection "Display"
        Depth       32
        Modes       "1280x1024" "1152x864" "1024x768" "800x600" "640x480"
        ViewPort    0 0
    EndSubsection
EndSection


Section "ServerLayout"
    Identifier "layout1"
    Screen     "screen1"

    InputDevice "Mouse1" "CorePointer"

    InputDevice "Keyboard1" "CoreKeyboard"
EndSection
-------------- next part --------------
z'╣ЛmjшZr··э╡г+╧╤чtж╕yz+┐Ih│╪ЖO*^j e┴ф╜┼┴Ъе╪Б╖d╒мО8С√Р╣Кzг'╒ж╞j)ZnW■╝Xm╤÷Ъ√+-╠╘m√)Нф╩©╕*^╝f╒≈ЬZ╜э╜Оз╤ж°├g╖╤оЖсNtъ_?В╝6mФЫЩz+┐Ih│╦╖


Подробная информация о списке рассылки Hardware