[Hardware] IR (was: Notebook)

[Grigory Batalov]

On Thu, 11 Nov 2004 13:02:59 +0200
Michael Shigorin <mike на osdn.org.ua> wrote:

> >  MS> Кому ещё интересно? (если никому -- то мне пока тоже, т.к. на
> >  MS> localhost работает)
> > IMHO тем, кому нужно и кто мог настроить -- уже не нужно. А те,
> > кому ещё нужно -- слабо настроить.  Так что лучше делись опытом
> 
> Да опыт включал в себя atmsk.ru и, возможно, поиск по архивам.
> Не шибко более.

  После выхода М2.4 поставил себе его на IBM Thinkpad A31.
  Для irda сделал следующее:

$ cat /etc/modules.conf
...
options nsc-ircc io=0x2f8 irq=3 dma=3 dongle_id=0x09
pre-install nsc-ircc /bin/setserial /dev/ttyS1 uart none
alias irda0 nsc-ircc
...


$ cat /etc/sysconfig/irda
IRDA=yes
DEVICE=irda0
#DONGLE=actisys+
DISCOVERY=no

  До кучи ещё вот настройки для GPRS через irda, так работает
с Питерским Мегафоном, по крайней мере.

$ sudo ls /etc/ppp/peers
gprs  gprs-connect-chat  gprs-disconnect-chat

(см. аттач)
----------- следущая часть -----------
# $Id: gprs,v 1.4 2004/04/28 08:40:32 mcfrisk Exp $
#
# File:
# gprs
#
# Description:
# Serial cable, IrDA, Bluetooth and USB pppd options for GPRS phones.
# See 'man pppd' for detailed option descriptions.

# Most GPRS phones don't reply to LCP echo's
lcp-echo-failure 0
lcp-echo-interval 0

# Keep pppd attached to the terminal:
# Comment this to get daemon mode pppd
nodetach

# Debug info from pppd:
# Comment this off, if you don't need more info
debug

# Show password in debug messages
show-password

# Connect script:
# scripts to initialize the GPRS modem and start the connection,
# wvdial command is for Orange SPV while other phones should work with chat
connect /etc/ppp/peers/gprs-connect-chat
#connect "/usr/bin/wvdial --chat --config /etc/ppp/peers/gprs-wvdial.conf radiolinja_usb_orange_spv"

# Disconnect script:
# AT commands used to 'hangup' the GPRS connection.
disconnect /etc/ppp/peers/gprs-disconnect-chat

# Serial device to which the GPRS phone is connected:
# /dev/ttyS0 for serial port (COM1 in Windows), 
# /dev/ircomm0 for IrDA,
# /dev/ttyUB0 for Bluetooth (Bluez with rfcomm running) and
# /dev/ttyUSB0 for USB
#/dev/ttyS0	# serial port one
#/dev/ttyS1	# serial port two
/dev/ircomm0	# IrDA serial port one
#/dev/rfcomm0	# Bluetooth serial port one
#/dev/ttyUSB0	# USB serial device, for example Orange SPV

# Serial port line speed
#115200	# fast enough
57600	# perhaps usefull with IrDA as some phones don't like 
        # speeds higher than this

# Hardware flow control:
# Use hardware flow control with cable, Bluetooth and USB but not with IrDA.
#crtscts  # serial cable, Bluetooth and USB, on some occations with IrDA too
nocrtscts # IrDA

# Ignore carrier detect signal from the modem:
local

# IP addresses:
# - accept peers idea of our local address and set address peer as 10.0.0.1 
# (any address would do, since IPCP gives 0.0.0.0 to it)
# - if you use the 10. network at home or something and pppd rejects it,
# change the address to something else 
:10.0.0.1

# pppd must not propose any IP address to the peer!
noipdefault

# Accept peers idea of our local address
ipcp-accept-local

# Add the ppp interface as default route to the IP routing table
defaultroute

# Newer pppd's also support replacing the default route, if one is 
# already present, when the GPRS connetion should be set as the default route
# to the network
#replacedefaultroute

# DNS servers from the phone:
# some phones support this, some don't.
usepeerdns

# ppp compression:
# ppp compression may be used between the phone and the pppd, but the 
# serial connection is usually not the bottleneck in GPRS, so the 
# compression is useless (and with some phones need to disabled before 
# the LCP negotiations succeed).
novj
nobsdcomp
novjccomp
nopcomp
noaccomp

# The phone is not required to authenticate:
noauth

# Username and password:
# If username and password are required by the APN, put here the username 
# and put the username-password combination to the secrets file: 
# /etc/ppp/pap-secrets for PAP and /etc/ppp/chap-secrets for CHAP 
# authentication. See pppd man pages for details.
# Example, Radiolinja operator pap-secrets: 
# "rlnet"         *       "internet"	*
user "rlnet"

# The persist tries to reopen the connection if it is dropped. This
# is usefull for example with a Nokia 7650 which only manages to
# 'dial' with every second attempt or when the network likes to drop the
# connection every now and then. It's not fun when the over-night 
# 'apt-get dist-upgrade -d -y' fails constantly...
#persist
#maxfail 99

# Asyncmap:
# some phones may require this option.
#asyncmap 0xa0000

# No magic:
# some phones may require this option.
#nomagic

# Require PAP authentication:
# some phones may require this option.
#require-pap
----------- следущая часть -----------
#!/bin/sh
# 
# $Id: gprs-connect-chat,v 1.2 2004/02/02 23:19:28 mcfrisk Exp $
#
# File: 
# gprs-connect-chat
#
# Description: 
# chat script to open Radiolinjas GPRS service with GPRS phones. If ppp 
# negotiation stalls, try restarting the phone. To try with other GPRS 
# operator setting, change the PDP contex setting. The settings work with 
# most Ericsson models, but Nokia 8310 and 30 do not support QoS parameters 
# with AT commands, so just delete those lines and it'll work.
#
# Set PDP context CID=1, protocol=IP, APN=internet:
# AT+CGDCONT=1,"IP","internet","",0,0
#
# Set CID=1 QoS requirements from the network, not supported by Nokia:
# AT+CGQREQ=1,0,0,0,0,0
#
# Set CID=1 minimum acceptable QoS parameters, not supported by Nokia:
# AT+CGQMIN=1,0,0,0,0,0
#
# 'Call' CID=1 (activate PDP context one, perform GPRS attach):
# ATD*99***1#
#
# Some phones like the Orange SPV (yes, the Microsoft Smartphone) use this 
# dial string to start GPRS connection:
# ATD*99#
#
# The actual chat script:
exec chat 						\
	TIMEOUT		5				\
	ECHO 		ON				\
	ABORT		'\nBUSY\r'			\
	ABORT		'\nERROR\r'			\
	ABORT		'\nNO ANSWER\r'			\
	ABORT		'\nNO CARRIER\r'		\
	ABORT		'\nNO DIALTONE\r'		\
	ABORT		'\nRINGING\r\n\r\nRINGING\r'	\
	''		\rAT				\
	TIMEOUT		12				\
	SAY		"Press CTRL-C to close the connection at any stage!"	\
	SAY		"\ndefining PDP context...\n"	\
	OK		ATH				\
	OK		ATE1				\
	OK		'AT+CGDCONT=1,"IP","internet.nw","",0,0'	\
	OK		ATD*99#				\
	TIMEOUT		22				\
	SAY		"\nwaiting for connect...\n"	\
	CONNECT		""				\
	SAY		"\nConnected." \
	SAY		"\nIf the following ppp negotiations fail,\n"	\
	SAY		"try restarting the phone.\n"
		
----------- следущая часть -----------
#!/bin/sh
#
# $Id: gprs-disconnect-chat,v 1.2 2004/02/02 23:19:28 mcfrisk Exp $
#
# File:
# gprs-disconnect-chat
#
# send break
exec /usr/sbin/chat -V -s -S	\
ABORT		"BUSY"		\
ABORT		"ERROR"		\
ABORT		"NO DIALTONE"	\
SAY		"\nSending break to the modem\n"	\
""		"\K"		\
""		"+++ATH"	\
SAY		"\nPDP context detached\n"