[Comm] Картридер

[Topper]

Приветствую! приобрел себе картридер (внутренний, нонеймовый, 7-в-1, без
проблем работающий под виндой). никак не удается завести его под ALM2.4.
вот вывод dmesg:

SCSI subsystem driver Revision: 1.00
Initializing USB Mass Storage driver...
usb.c: registered new driver usb-storage
scsi0 : SCSI emulation for USB Mass Storage devices
  Vendor: Generic   Model: USB Storage-CFC   Rev: I16A
  Type:   Direct-Access                      ANSI SCSI revision: 02
WARNING: USB Mass Storage data integrity not assured
USB Mass Storage device found at 2
USB Mass Storage support registered.
Attached scsi removable disk sda at scsi0, channel 0, id 0, lun 0
sda: Unit Not Ready, sense:
Current 00:00: sense key Not Ready
Additional sense indicates Medium not present
sda : READ CAPACITY failed.
sda : status = 1, message = 00, host = 0, driver = 08
Current sd00:00: sense key Not Ready
Additional sense indicates Medium not present
sda : block size assumed to be 512 bytes, disk size 1GB.
 sda: I/O error: dev 08:00, sector 0
 I/O error: dev 08:00, sector 0
ldm_validate_partition_table(): Disk read failed.
 I/O error: dev 08:00, sector 0
 unable to read partition table
sda: Unit Not Ready, sense:
Current 00:00: sense key Not Ready
Additional sense indicates Medium not present
sda : READ CAPACITY failed.
sda : status = 1, message = 00, host = 0, driver = 08
Current sd00:00: sense key Not Ready
Additional sense indicates Medium not present
sda : block size assumed to be 512 bytes, disk size 1GB.
sda: Write Protect is off
 sda: I/O error: dev 08:00, sector 0
 I/O error: dev 08:00, sector 0
ldm_validate_partition_table(): Disk read failed.
 I/O error: dev 08:00, sector 0
 unable to read partition table

#lsmod|grep usb:

usb-storage           139744   0
scsi_mod               95296   2  [sd_mod usb-storage]
usb-uhci               21676   0  (unused)
usbcore                58464   1  [usb-storage usb-uhci]

содержимое modules.conf:

options ide-scsi ignore="hdc"
above snd-emu10k1 snd-pcm-oss
alias sound-slot-0 snd-emu10k1
above snd-pcm-oss snd-mixer-oss
alias usb-interface usb-uhci
alias eth0 ne2k-pci
# I2C module options
alias char-major-89 i2c-dev

попытка внести в modules.conf 

option scsi_mod max_scsi_luns=0xffffff

успеха не принесла: начинается ругань на неверные данные в modules.conf.
хотя, насколько я осознал проблемму, именно это мне и поможет заставить
эту железяку работать.

собственно вот... куда копать и что делать?

-- 
Всем спасибо, все свободны
ALT Linux 2.4 Master
Tualatin-1400/384/Ti4200
Registred Linux User #339833