[Comm] AltLinux Master не хочет признавать SATA диски:(

[Овечкин Влад]

  Добрый день! Столкнулся с такой вот проблемой - имею AltLinux Master 2.2 с обновлённым ядром 2.4.26-std-smp. Мне требуется сделать RAID5 из четырёх саташных дисков Seagate на мамке ASUS P4 C800 Deluxe - 2 по 120 Гб подключены к Serial ATA RAID connectors - они встали великолепно - как и положено на sda и sdb соответственно (т. к. вроде все стандартные сказёвые модули я поставил), а другие 2 по 160 Гб подключены к разъёму RAID ATA - вот их то система и отказвается правильно воспринимать:-(  Т.е. логи есть, а фактически их нет...
  Логи следующие: 
  Aug  4 13:08:32 s-1 kernel: Uniform Multi-Platform E-IDE driver Revision: 7.00beta4-2.4 
  Aug  4 13:08:32 s-1 kernel: ide: Assuming 33MHz system bus speed for PIO modes; override with idebus=xx 
  Aug  4 13:08:32 s-1 kernel: hda: ST380011A, ATA DISK drive 
  Aug  4 13:08:32 s-1 kernel: ide1: ports already in use, skipping probe 
  Aug  4 13:08:32 s-1 kernel: ide0 at 0x1f0-0x1f7,0x3f6 on irq 14 
  Aug  4 13:08:32 s-1 kernel: hda: attached ide-disk driver. 
  Aug  4 13:08:32 s-1 kernel: hda: host protected area => 1 
  Aug  4 13:08:32 s-1 kernel: hda: 156301488 sectors (80026 MB) w/2048KiB Cache, CHS=9729/255/63 
  Aug  4 13:08:32 s-1 kernel: Partition check: 
  Aug  4 13:08:32 s-1 kernel:  hda: hda1 hda2 < hda5 hda6 hda7 hda8 hda9 > 
  Aug  4 13:08:32 s-1 kernel: md: md driver 0.90.0 MAX_MD_DEVS=256, MD_SB_DISKS=27 
  Aug  4 13:08:32 s-1 kernel: md: Autodetecting RAID arrays. 
  Aug  4 13:08:32 s-1 kernel: md: autorun ... 
  Aug  4 13:08:32 s-1 kernel: md: ... autorun DONE. 
  Aug  4 13:08:32 s-1 kernel: SCSI subsystem driver Revision: 1.00 
  Aug  4 13:08:32 s-1 kernel: usb.c: USB bus 2 deregistered 
  Aug  4 13:08:32 s-1 kernel: usb.c: USB disconnect on device 00:1d.2-0 address 1 
  Aug  4 13:08:32 s-1 kernel: ata1: SATA max UDMA/133 cmd 0xF8FB2200 ctl 0xF8FB2238 bmdma 0x0 irq 23 
  Aug  4 13:08:32 s-1 kernel: ata2: SATA max UDMA/133 cmd 0xF8FB2280 ctl 0xF8FB22B8 bmdma 0x0 irq 23 
  Aug  4 13:08:32 s-1 kernel: usb.c: USB bus 3 deregistered 
  Aug  4 13:08:32 s-1 kernel: usb.c: USB disconnect on device 00:1d.3-0 address 1 
  Aug  4 13:08:32 s-1 kernel: inserting floppy driver for 2.4.26-std-smp-alt5 
  Aug  4 13:08:32 s-1 kernel: Floppy drive(s): fd0 is 1.44M 
  Aug  4 13:08:32 s-1 kernel: FDC 0 is a post-1991 82077 
  Aug  4 13:08:32 s-1 kernel: ata1: dev 0 ATA, max UDMA/133, 234441648 sectors (lba48) 
  Aug  4 13:08:32 s-1 kernel: ata1: dev 0 configured for UDMA/133 
  Aug  4 13:08:32 s-1 kernel: usb.c: USB bus 4 deregistered 
  Aug  4 13:08:32 s-1 kernel: ehci_hcd 00:1d.7: remove state 3 
  Aug  4 13:08:32 s-1 kernel: usb.c: USB disconnect on device 00:1d.7-0 address 1 
  Aug  4 13:08:32 s-1 kernel: ata2: dev 0 ATA, max UDMA/133, 234441648 sectors (lba48) 
  Aug  4 13:08:32 s-1 kernel: ata2: dev 0 configured for UDMA/133 
  Aug  4 13:08:32 s-1 kernel: scsi0 : sata_promise 
  Aug  4 13:08:32 s-1 kernel: scsi1 : sata_promise 
  Aug  4 13:08:32 s-1 kernel: usb.c: USB bus 5 deregistered 
  Aug  4 13:08:32 s-1 kernel: usb.c: deregistering driver usbdevfs 
  Aug  4 13:08:32 s-1 kernel:   Vendor: ATA       Model: ST3120026AS       Rev: 1.02 
  Aug  4 13:08:32 s-1 kernel:   Type:   Direct-Access                      ANSI SCSI revision: 05 
  Aug  4 13:08:32 s-1 kernel: usb.c: deregistering driver hub 
  Aug  4 13:08:32 s-1 kernel:   Vendor: ATA       Model: ST3120026AS       Rev: 1.02 
  Aug  4 13:08:32 s-1 kernel:   Type:   Direct-Access                      ANSI SCSI revision: 05 
  Aug  4 13:08:32 s-1 kernel: scsi : 0 hosts left. 
  Aug  4 13:08:32 s-1 kernel: ata1: SATA max UDMA/133 cmd 0xF8F79200 ctl 0xF8F79238 bmdma 0x0 irq 23 
  Aug  4 13:08:32 s-1 kernel: ata2: SATA max UDMA/133 cmd 0xF8F79280 ctl 0xF8F792B8 bmdma 0x0 irq 23 
  Aug  4 13:08:32 s-1 kernel: ata1: dev 0 ATA, max UDMA/133, 234441648 sectors (lba48) 
  Aug  4 13:08:32 s-1 kernel: ata1: dev 0 configured for UDMA/133 
  Aug  4 13:08:32 s-1 kernel: ata2: dev 0 ATA, max UDMA/133, 234441648 sectors (lba48) 
  Aug  4 13:08:32 s-1 kernel: ata2: dev 0 configured for UDMA/133 
  Aug  4 13:08:32 s-1 kernel: scsi0 : sata_promise 
  Aug  4 13:08:32 s-1 kernel: scsi1 : sata_promise 
  Aug  4 13:08:32 s-1 kernel:   Vendor: ATA       Model: ST3120026AS       Rev: 1.02 
  Aug  4 13:08:32 s-1 kernel:   Type:   Direct-Access                      ANSI SCSI revision: 05 
  Aug  4 13:08:32 s-1 kernel:   Vendor: ATA       Model: ST3120026AS       Rev: 1.02 
  Aug  4 13:08:32 s-1 kernel:   Type:   Direct-Access                      ANSI SCSI revision: 05 
  Aug  4 13:08:32 s-1 kernel: scsi : 0 hosts left. 
  Aug  4 13:08:32 s-1 kernel: parport0: PC-style at 0x378 (0x778) [PCSPP,TRISTATE,EPP] 
  Aug  4 13:08:32 s-1 kernel: parport0: irq 7 detected 
  Aug  4 13:08:32 s-1 kernel: ata1: SATA max UDMA/133 cmd 0xF8F79200 ctl 0xF8F79238 bmdma 0x0 irq 23 
  Aug  4 13:08:32 s-1 kernel: ata2: SATA max UDMA/133 cmd 0xF8F79280 ctl 0xF8F792B8 bmdma 0x0 irq 23 
  Aug  4 13:08:32 s-1 kernel: ata1: dev 0 ATA, max UDMA/133, 234441648 sectors (lba48) 
  Aug  4 13:08:32 s-1 kernel: ata1: dev 0 configured for UDMA/133 
  Aug  4 13:08:32 s-1 kernel: ata2: dev 0 ATA, max UDMA/133, 234441648 sectors (lba48) 
  Aug  4 13:08:32 s-1 kernel: ata2: dev 0 configured for UDMA/133 
  Aug  4 13:08:32 s-1 kernel: scsi0 : sata_promise 
  Aug  4 13:08:32 s-1 kernel: scsi1 : sata_promise 
  Aug  4 13:08:32 s-1 kernel:   Vendor: ATA       Model: ST3120026AS       Rev: 1.02 
  Aug  4 13:08:32 s-1 kernel:   Type:   Direct-Access                      ANSI SCSI revision: 05 
  Aug  4 13:08:32 s-1 kernel:   Vendor: ATA       Model: ST3120026AS       Rev: 1.02 
  Aug  4 13:08:32 s-1 kernel:   Type:   Direct-Access                      ANSI SCSI revision: 05 
  Aug  4 13:08:32 s-1 kernel: scsi : 0 hosts left. 


  С уважением,Овечкин Влад.


----------- следующая часть -----------
Вложение в формате HTML было удалено...
URL: <http://lists.altlinux.org/pipermail/community/attachments/20040805/f3ab5c3d/attachment-0003.html>