--------------------------------------------- * The following section contains information about your system Tue Mar 29 04:51:07 EEST 2005 Output of uname -a Linux server.psv.com.ua 2.6.12-std26-up-alt7 #1 Mon Dec 5 15:45:18 MSK 2005 i686 unknown unknown GNU/Linux --------------------------------------------- * The following section contains information about your network * interfaces. The one you chose for PPPoE should contain the words: * 'UP' and 'RUNNING'. If it does not, you probably have an Ethernet * driver problem. Output of ifconfig -a eth0 Link encap:Ethernet HWaddr 00:07:E9:3B:77:5E inet addr:192.168.1.1 Bcast:192.168.1.255 Mask:255.255.255.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:202718 errors:0 dropped:0 overruns:0 frame:0 TX packets:372274 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:54491043 (51.9 MiB) TX bytes:445086432 (424.4 MiB) eth1 Link encap:Ethernet HWaddr 00:02:44:9E:29:67 UP BROADCAST RUNNING NOARP MULTICAST MTU:1500 Metric:1 RX packets:7 errors:0 dropped:0 overruns:0 frame:0 TX packets:16 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:426 (426.0 b) TX bytes:960 (960.0 b) Interrupt:17 Base address:0x4c00 eth2 Link encap:Ethernet HWaddr 00:02:44:A8:F4:C2 inet addr:192.168.11.2 Bcast:192.168.11.255 Mask:255.255.255.0 UP BROADCAST RUNNING MULTICAST MTU:1500 Metric:1 RX packets:7 errors:0 dropped:0 overruns:0 frame:0 TX packets:12 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:1000 RX bytes:420 (420.0 b) TX bytes:720 (720.0 b) Interrupt:19 Base address:0x8800 lo Link encap:Local Loopback inet addr:127.0.0.1 Mask:255.0.0.0 UP LOOPBACK RUNNING MTU:16436 Metric:1 RX packets:1699 errors:0 dropped:0 overruns:0 frame:0 TX packets:1699 errors:0 dropped:0 overruns:0 carrier:0 collisions:0 txqueuelen:0 RX bytes:136308 (133.1 KiB) TX bytes:136308 (133.1 KiB) --------------------------------------------- * The following section contains information about kernel modules * If the module for your Ethernet card is 'tulip', you might * want to look for an updated version at http://www.scyld.com Output of lsmod Module Size Used by nfsd 209408 9 exportfs 5888 1 nfsd lockd 60712 2 nfsd sunrpc 133828 12 nfsd,lockd af_packet 21640 10 ppp_synctty 9472 0 ppp_async 11008 0 crc_ccitt 2176 1 ppp_async ppp_generic 28180 2 ppp_synctty,ppp_async slhc 7296 1 ppp_generic 8139too 25088 0 e100 35968 0 mii 5760 2 8139too,e100 ipt_state 2048 8 ipt_REDIRECT 2176 5 ip_nat_irc 2816 0 ip_nat_ftp 3456 0 ip_conntrack_irc 71952 1 ip_nat_irc ip_conntrack_ftp 72720 1 ip_nat_ftp ipt_REJECT 5376 0 ipt_owner 3200 0 ipt_MASQUERADE 3456 0 ipt_limit 2432 9 ipt_LOG 7168 4 iptable_nat 22740 5 ipt_REDIRECT,ip_nat_irc,ip_nat_ftp,ipt_MASQUERADE iptable_mangle 2944 0 iptable_filter 3072 1 ip_tables 19840 10 ipt_state,ipt_REDIRECT,ipt_REJECT,ipt_owner,ipt_MASQUERADE,ipt_limit,ipt_LOG,iptable_nat,iptable_mangle,iptable_filter ip_conntrack 43064 7 ipt_state,ip_nat_irc,ip_nat_ftp,ip_conntrack_irc,ip_conntrack_ftp,ipt_MASQUERADE,iptable_nat ohci1394 32948 0 ieee1394 97720 1 ohci1394 nvidia 3708168 0 snd_intel8x0 32192 0 snd_ac97_codec 77436 1 snd_intel8x0 snd_pcm_oss 51744 0 snd_seq_dummy 3972 0 snd_seq_oss 33024 0 snd_seq_midi_event 7040 1 snd_seq_oss snd_seq 49296 5 snd_seq_dummy,snd_seq_oss,snd_seq_midi_event snd_seq_device 8716 3 snd_seq_dummy,snd_seq_oss,snd_seq snd_mixer_oss 18048 1 snd_pcm_oss snd_pcm 85384 3 snd_intel8x0,snd_ac97_codec,snd_pcm_oss snd_timer 23812 2 snd_seq,snd_pcm snd 53636 10 snd_intel8x0,snd_ac97_codec,snd_pcm_oss,snd_seq_dummy,snd_seq_oss,snd_seq,snd_seq_device,snd_mixer_oss,snd_pcm,snd_timer soundcore 9184 1 snd snd_page_alloc 9860 2 snd_intel8x0,snd_pcm i2c_i801 8844 0 i2c_core 21008 1 i2c_i801 hw_random 5396 0 intel_agp 22428 1 agpgart 34248 2 nvidia,intel_agp parport_pc 38468 0 parport 33864 1 parport_pc 8250_pnp 8704 0 8250 32100 3 8250_pnp serial_core 21120 1 8250 evdev 9344 0 pcspkr 3652 0 ehci_hcd 32904 0 uhci_hcd 30864 0 usbcore 114012 3 ehci_hcd,uhci_hcd dm_mod 55868 0 rtc 12216 0 reiserfs 248176 4 ata_piix 9604 4 libata 46468 1 ata_piix sd_mod 18448 5 scsi_mod 131272 2 libata,sd_mod ide_disk 17024 0 ide_generic 1408 0 [permanent] piix 10244 0 [permanent] ide_core 120856 3 ide_disk,ide_generic,piix --------------------------------------------- * The following section lists your routing table. * If you have an entry which starts with '0.0.0.0', you probably * have defined a default route and gateway, and pppd will * not create a default route using your ISP. Try getting * rid of this route. Output of netstat -n -r Kernel IP routing table Destination Gateway Genmask Flags MSS Window irtt Iface 192.168.1.0 0.0.0.0 255.255.255.0 U 0 0 0 eth0 192.168.11.0 0.0.0.0 255.255.255.0 U 0 0 0 eth2 127.0.0.0 0.0.0.0 255.0.0.0 U 0 0 0 lo --------------------------------------------- Contents of /etc/resolv.conf * The following section lists DNS setup. * If you can browse by IP address, but not name, suspect * a DNS problem. nameserver 192.168.1.1 --------------------------------------------- * The following section lists /etc/ppp/options. * You should have NOTHING in that file. Contents of /etc/ppp/options --------------------------------------------- * The following section identifies your Ethernet interface * and user name. Some ISP's need 'username'; others * need 'username@isp.com'. Try both ETH=eth1; USER=elan-adsl --------------------------------------------- * The following section shows the pppd command we will invoke pppd invocation /usr/bin/setsid /usr/sbin/pppd pty '/usr/sbin/pppoe -p /var/run/pppoe.conf-adsl.pid.pppoe -I eth1 -T 80 -U -m 1412 ' noipdefault noauth default-asyncmap defaultroute hide-password nodetach mtu 1492 mru 1492 noaccomp noccp nobsdcomp nodeflate nopcomp novj novjccomp user elan-adsl lcp-echo-interval 20 lcp-echo-failure 3 debug --------------------------------------------- using channel 6 Using interface ppp0 Connect: ppp0 <--> /dev/pts/4 sent [LCP ConfReq id=0x1 ] sent [LCP ConfReq id=0x1 ] sent [LCP ConfReq id=0x1 ] sent [LCP ConfReq id=0x1 ] sent [LCP ConfReq id=0x1 ] sent [LCP ConfReq id=0x1 ] sent [LCP ConfReq id=0x1 ] sent [LCP ConfReq id=0x1 ] sent [LCP ConfReq id=0x1 ] sent [LCP ConfReq id=0x1 ] LCP: timeout sending Config-Requests Connection terminated. Waiting for 1 child processes... script /usr/sbin/pppoe -p /var/run/pppoe.conf-adsl.pid.pppoe -I eth1 -T 80 -U -m 1412 -D /tmp/pppoe-debug-12755/pppoe-debug.txt-0, pid 12812 pppoe: Timeout waiting for PADO packets Script /usr/sbin/pppoe -p /var/run/pppoe.conf-adsl.pid.pppoe -I eth1 -T 80 -U -m 1412 -D /tmp/pppoe-debug-12755/pppoe-debug.txt-0 finished (pid 12812), status = 0x1 --------------------------------------------- * The following section is an extract from your log. * Look for error messages from pppd, such as * a lack of kernel support for PPP, authentication failure * etc. Extract from /var/log/messages Dec 20 14:58:20 server pppd[10395]: pppd 2.4.2 started by root, uid 0 Dec 20 14:58:20 server pppd[10395]: Using interface ppp0 Dec 20 14:58:20 server pppd[10395]: Connect: ppp0 <--> /dev/pts/5 Dec 20 14:58:24 server pppoe[8925]: Timeout waiting for PADO packets Dec 20 14:58:24 server pppd[8924]: Exit. Dec 20 14:58:51 server pppd[10395]: LCP: timeout sending Config-Requests Dec 20 14:58:51 server pppd[10395]: Connection terminated. Dec 20 14:58:55 server pppoe[10396]: Timeout waiting for PADO packets Dec 20 14:58:55 server pppd[10395]: Exit. --------------------------------------------- * The following section is a dump of the packets * sent and received by rp-pppoe. If you don't see * any output, it's an Ethernet driver problem. If you only * see three PADI packets and nothing else, check your cables * and modem. Make sure the modem lights flash when you try * to connect. Check that your Ethernet card is in * half-duplex, 10Mb/s mode. If all else fails, * try using pppoe-sniff. rp-pppoe debugging dump rp-pppoe-3.5 04:51:07.549 SENT PPPoE Discovery (8863) PADI sess-id 0 length 12 SourceAddr 00:02:44:9e:29:67 DestAddr ff:ff:ff:ff:ff:ff 01 01 00 00 01 03 00 04 0c 32 00 00 .........2.. 04:51:12.549 SENT PPPoE Discovery (8863) PADI sess-id 0 length 12 SourceAddr 00:02:44:9e:29:67 DestAddr ff:ff:ff:ff:ff:ff 01 01 00 00 01 03 00 04 0c 32 00 00 .........2.. 04:51:22.548 SENT PPPoE Discovery (8863) PADI sess-id 0 length 12 SourceAddr 00:02:44:9e:29:67 DestAddr ff:ff:ff:ff:ff:ff 01 01 00 00 01 03 00 04 0c 32 00 00 .........2..